Ingenico iCT220 Ethernet configuration

Windows 10 Start

Overview

The 802.1x protocol is the protocol that is used for wired access to the University's network (PittNet) through publicly accessible network ports. These connections may be located in residence halls, classrooms, conference rooms, or other public areas. The simplest way to connect is to use our automated wizard. If the wizard does not work, you can use the steps in this document to manually configure your Windows computer to use network ports in public areas and residence halls. You must have administrative rights to your computer to complete these steps.

Before you manually configure your computer, be sure to install the required InCommon certificates using the steps in the help sheet titled .

Section 1 - Enable the Wired Auto Config Service

Select servicesBe sure you have connected your computer to the network port with an Ethernet cable before you begin the steps below.

  1. From the Windows 10 Start screen, type Control Panel and then press the Enter key. This will search for and automatically open the Control Panel.
    Note: In the Control Panel, set View by: to Large Icons.
  2. Select Administrative Tools.
  3. Select Services.
  4. Right click on Wired AutoConfig and select Properties.
  5. Set Startup type to Automatic.
  6. Click on Start and wait for the service to start.
  7. Click Apply, then click OK.

Set the Local Area Connection to be the Priority Connection

  1. From the Windows 10 Start screen, type Control Panel and then press the Enter key. This will search for and automatically open the Control Panel.
    Note: In the Control Panel, set View by: to Large Icons.
  2. Select Network and Sharing Center.
  3. Select Change adapter settings on the left-hand side of the screen.
  4. Press the Alt key to activate the menu bar.
  5. Select Advanced from the menu bar, then select Advanced Settings.
  6. Below Connections, use the Up arrow to move the Ethernet to the top of the list.
  7. Click OK.

Wired Auto ConfigModify the Ethernet Card Speed and Power Management

Before beginning the steps in the rest of this document, unplug your Ethernet cable from your computer.

  1. You should still be in Network Connections. Right click on Ethernet and then select Properties.
  2. Click Configure.
  3. Click the Advanced tab and set the Ethernet card Speed & Duplex settings to 100 Mbps Full Duplex.
    Note: The option in the Property field may be named Link Speed & Duplex or just Speed & Duplex.
  4. Click the Power Management tab and uncheck the box next to "Allow the computer to turn off this device to save power."
Apply A login screen prompt will appear. Enter your University Computing Account Username and Password. Network and sharing center Advanced settings

Ingenico isc250 Ethernet setup

Ingenico ict250 Paper Rolls Staples

Ingenico iCT220 print receipt

Ingenico eft930g Network Logon

Ingenico ict250 key injection